You would have seen one of these in my Autumn Crafty Goodness post.
So, here's a quick tutorial on how to make your very own protective cellphone cosy.
You will need:
I've since had orders from family to make a few more, apparently my toddler isn't the only drooling baby who likes to pinch phones!
The good thing about these cosies is that because they have absorbency and waterproofing they help to protect your phone from those occasional wet accidents. Like a water-bottle leaking through your bag, or getting caught in a down-pour with your phone in your pocket.
So, here's a quick tutorial on how to make your very own protective cellphone cosy.
You will need:
- 1x fabric piece for the outer (such as cotton)
- 1x absorbent piece for the inner (such as an old cloth nappy, towelling or microfibre)
- 1x PUL piece for the waterproof inner
- 1x snap set
First up, to find out how big your fabric pieces need to be, measure your cellphone - mine is 5cm by 11cm and 1cm thick.
Add 4cm to the width and 18cm to the length. If your phone is thicker than 2cm, you will need to add another 1cm to the width.
My fabric pieces will need to be 9cm x 29cm.
My fabric pieces will need to be 9cm x 29cm.
Cut out your fabric pieces to the dimensions you worked out above.
Lay the PUL on top of the outer piece right side down.
Lay the absorbent piece on top of the two. Make sure the edges of all 3 line up nicely. You can pin into place if you wish.
Sew around the edge of the pieces using a 1/4" seam. Start sewing on a long side and leave a gap at the end to turn.
Clip the corners.
Turn inside out so the the right sides are showing - the absorbent piece should be in the middle.
Fold up the length to just over halfway, pin into place. This will create the pocket your phone will sit in.
Top-stitch around the three edges (don't top-stitch across the bottom), start at the bottom of the pocket and ensure the gap is closed at the top.
Pop your phone into the cosy and find where you'd like to attach the snap pieces, mark with a pin or fabric marker.
Attach the snap pieces and your done.
Attach the snap pieces and your done.




